Xhorse VVDI Bee Key Tool Lite is a new device that supports to generate remote on Android phones. Besides, it also supports to generate and clone transponder, detect remote frequency, clone IC/ID, unlock Toyota smart key, etc. Read this post to learn how to use.
Xhorse VVDI Key Tool Lite Configuration
Key Slot Coil: 1) Remote frequency detection; 2) Chip clone collection; 3) Chip and remote reading coil(125Khz, 134KHz).
IC Card Identification
Working Status Indicator Light: Flash - upgrade mode, Always On - working mode
Connect to Phone TYPE-C Interface
Remote Programming Cable Port
Remote Programming Cable
Xhorse VVDI Key Tool Lite Connection Method
How to power on?
How to power off?
Disconnect the TYPE-C cable.
Note: If there is a prompt on the right side of the interface, open the phone settings and turn on the OTG connection switch.
Main function 1: Generate Remote & Transponder, Frequency Detection
Vehicle Remote: supportXhorse XK wire remote, XN wireless remote, XE wireless remote and Xhorse smart remote generation.
Generate Transponder: support VVDI XT27 Super Remote generation.
Frequency Detection: supportcommon car key frequency detection.
Main Function 2: Transponder Clone
As shown in the pic, move the Key Tool Lite close to the ignition switch, and turn the ignition key on and off repeatedly.
(For push start system, use the Key Tool Lite close to the emergency switch area, then press the start button repeatedly).
Transponder Clone Interface Process
Take out original key, suggest put VVDI super chip or wireless remote to write data.
Main Function 3: IC/ID Clone
Special Functions
* ID48 96bit clone is not supported currently.
